Step 1: Create an AUTOBOOT.PUB.SYS file, as follows: :hello manager.sys :editor /a 1 START NORECOVERY#@ 2 // .... /C "#" TO '13 IN 1 <That's all there is to it. AUTOBOOT can be toggled on and off easily after that, with the ISL AUTOBOOT ON/OFF command. If I understand the second part of your question, the above procedure will NOT result in a memory dump. If you need to perform one, simply intercept the AUTOBOOT (by pressing any key within 10 seconds), reply Y to the question "Interact with IPL?", and then typing DUMP at the ISL prompt. --GillesSchipper? -- ChrisBartram - 17 May 2006> /C "@" TO '10 IN 1 << changes @ to be a LF >> / k autoboot.pub,unn Step 2: Mark AUTOBOOT file as SYSTEM FILE, via SYSGEN :hello manager.sys :sysgen sy aauto file=autoboot.pub.sys type=disc hold exit keep exit Step 3: Create new SLT tape Step 4: During re-boot, at ISL prompt, AUTOBOOT ON Step 5: boot from tape drive path (normally alternate path) and UPDATE CONFIG
| Topic Hp3000AutoReboot . { Edit | Attach | Backlinks: Web All webs | Printable | History: r2 < r1 More } |
|
Ideas, requests, problems regarding TWiki? Send feedback Note: Please contribute updates to this topic on TWiki.org at TWiki:TWiki.Hp3000AutoReboot |